Filter
Top Products
6-23Removal and Replacement
BACK PANEL REMOVAL
To remove the back panel, perform the following procedure:
1. Remove the window assembly.
2. Using a TORX T-15 screwdriver, remove the 5 screws that attach the trailing cable
rear tray to the back panel.
3. Using a TORX T-15 screwdriver, remove the screws that attach the back panel to the
electronics enclosure assembly. The C2858A has three screws and the C2859A has
four screws. Lift the back panel clear of the plotter.
Trailing Cable Rear Tray Screws (5)
Figure 6-16.
Back Panel Screws
C2858A (3) C2859A (4)
(C)C2858-42
(C)C2858-2