Filter
Top Products
1-6
Installation
2. Verify the Switch’s Operation
Installation
2. Verify the Switch’s Operation
This process verifies that the Switch 800T is operating properly.
Verify the Switch Hardware
1. Connect the supplied power cord to the switch’s power receptacle.
Figure 1-4. Back Panel of the Switch 800T
2. Plug the power cord into a properly grounded electrical outlet.
Note The Switch 800T does not have a power switch. It is powered on when the
switch’s power cord is connected to the switch and to a power source.
If your installation requires a different power cord than the one supplied with
the switch, be sure to use a power cord displaying the mark of the safety
agency that defines the regulations for power cords in your country. The mark
is your assurance that the power cord can be used safely with the switch.
3. Check the LEDs on the switch’s front panel.
Power Receptacle on
the Back of the Switch
SEDONA.BK : sed_1.fm5 Page 6 Thursday, February 27, 1997 10:11 AM