Filter
Top Products
1-16
Installation
4. Connect a Power Supply
Installation
4. Connect a Power Supply
The Switch 800T does not have a power switch. It is powered-on when the
power cord is plugged in. The switch’s power supply automatically adjusts to
any AC power source between 100-127 volts and 200-240 volts. There are no
voltage range settings to configure.
You can use one of the following to provide power to the Switch 800T:
■ The power cord provided with the Switch 800T.
OR
■ The optional HP J2962A AdvanceStack Redundant Power Supply (RPS).
To Use the Power Cord Provided with the Switch 800T:
Caution If you use a power cord that plugs into the power cord receptacle
(figure 1-13), do not use the optional redundant power supply (RPS).
If your installation requires a different power cord than the one
supplied with the switch, be sure to use a power cord displaying the
mark of the safety agency that defines the regulations for power cords
in your country. The mark is your assurance that the power cord can
be used safely with the switch.
1. Ensure that the switch is properly mounted. (Refer to “3. Mount the
Switch” on page 1-8.)
2. Plug the power cord into the switch’s power cord receptacle and into an
AC power source.
Figure 1-13. Plugging in the Power Cord
Power Cord Receptacle
on the Back of the Switch
SEDONA.BK : sed_1.fm5 Page 16 Thursday, February 27, 1997 10:11 AM