Filter
Top Products
1-23
Installation
6. Connect a Console Device (Optional)
Installation
3. When you see this message:
Waiting for speed sense. Press enter to continue.
Press [Enter]. You will then see the Switch 800T’s Main Menu.
Note If the terminal emulator you are using is not set to 9600 Bps, you will see
a series of meaningless characters. Press [Enter] to synchronize the switch
serial port speed with the terminal speed. The switch’s serial port can use
one of several speeds between 300 Bps and 38400 Bps. In most cases, the
switch’s Serial Link Baud Rate should be left at the (default) Speed
Sense setting. At this setting, it will automatically sense terminal speeds
in the above-mentioned range.
Figure 1-19. The Main Menu
4. If you want to continue with direct console management at this time, refer
to chapter 2, “Using the Console Interface”.
SEDONA.BK : sed_1.fm5 Page 23 Thursday, February 27, 1997 10:11 AM