Filter
Top Products
Engine test
NOTE: The product does not have an engine test button.
1. When the product is in the Ready state, press and hold the Auto-On/Auto-Off (power) button for
about seven seconds or until the Ready light turns off.
TIP: Optionally, unplug the power cord, and then plug the cord back in.
2. Make sure that at least one sheet of paper is loaded in the input tray.
3. Open the top door (print-cartridge door).
4. Release the rear door and allow it to open to its first stop position; open about 19 mm (.75 in).
5. Press and hold the Auto-On/Auto-Off (power) button.
NOTE: he control-panel lights cycle on and off sequentially twice, starting with the black-
cartridge light (top) and ending with the Ready light.
6. When the black-cartridge light turns on for the second time—the beginning of the second cycle—
close the rear door, and then within five seconds close the top door (print-cartridge door).
7. When the product finishes initializing, an engine test page prints.
ENWW
Tools for troubleshooting
209