Filter
Top Products
Table 30 Cabling pinouts
Pin
Signal
Description
1
Not supported Not supported
2
RxData
Receive data
3
TxData
Transmit data
4
Not supported Not supported
5
GND
Logic ground
6
Not supported Not supported
7
Not supported Not supported
8
Not supported Not supported
9
Not supported Not supported
A 3.0 m (10 ft) serial cable is provided with the switch. It can be converted from a DB-9
serial cab le to an RJ-45 serial cable by removing the adapter on the end of the cable.
To remove the adapter from the end of the DB - 9 serial cable:
1. Ensure that
thecableandbothscrewshavebeendisengaged.
2. Pull the ad
apter straight out, without moving it from side to side, to loosen the
seating of
the connector. If you move the adapter side to side, you might damage it.
CAUTION:
WhenremovingtheDB-9maleconnectorfromtheDTEport,donotuseexcessive
force or the DB-9 connector will split into two parts easily to prevent damage to the
switch’s DTE port.
142
SAN Switch technical specifications