Filter
Top Products
Powering on and off
The following sections provide information on powering specific SAN Switch models
on and off.
4/8 and 4/16 SAN Switch m odels
To power on:
1. Connect one end of the power cord to the AC inlet on the switch; connect the
other end to a power source.
2. Set the A C power switch to I.
The switch runs POST each time it is powered on, reset, or rebooted. POST requires
approximately three minutes.
To power off:
1. Set the A C power s witch to O.
2. Remove the power cords from the power sources.
NOTE:
Removing all power from the switch triggers a system reset. All devices are returned to
their initial state the next time the switch is powered on.
4/32, 4/32B and 4/64 SAN Switch models
Connect one or both power cords to the AC power inlets on the switch; connect the other
end to a power source.
To pow er on, set both AC power switches to I. Power is supplied to the switch as soon
as the first power supply is connected and p owered on.
To power off, set both AC power switches to O and remove the AC power cord from
the power source.
NOTE:
Removing all power from the switch triggers a system reset. All devices are returned to
their initial states the next time the switch is powered on.
66
Managing SAN Switches