IBM AA-RWF3A-TE Switch User Manual


 
3. At the Fabric Parameters prompt, enter y and press Enter:
Fabric Parameters (yes, y, no, n): (no) y
4. Enter a unique domain ID, such as the domain ID used by the previous switch, if
it is still available:
Domain: (1..239) [1] 3
5. Respond to the remaining prompts or press Ctrl+D to accept the default settings.
6. Issue the switchenable command to re-enable the switch.
7. Optional: Specify any custom status policies:
a. Issue the switchstatuspolicyset command. This command sets the
policy parameters that determine the overall switch status.
b. Customize the status polic ies.
To deactivate the alarm for a particular policy, enter 0 at the prompt for that policy.
InstalltheSFPtransceivers
The SAN Switch does not ship with SFPs. For a list of supported SFPs, see Table
2 on page 33.
The ports sele
cted for use in trunking groups must meet specific requirements. For a list of
these requirements, see the ISL Trunking chapter in the Fabric OS administrator’s guide.
To install the SFP transceivers:
1. Position the
transceiver so that it is oriented correctly and insert it into a port until the
latching mechanism clicks. The transceivers are keyed to ensure c orrect orientation.
If the transceiver d oes not install easily, make s ure it is oriented correctly.
For instructions specific to the transceiver you are using, see the transceiver
manufacturer’s documentation.
2. Repeat ste
p1for the remaining ports, as required.
SAN Switch installation guide
59