Filter
Top Products
Apply pow er to t
he switch and log in
Once a serial connection is established, apply power to the switch:
1. Connect the power cord to a power inlet on the switch and a power source, as
shown in Figur
e21.
NOTE:
The 4/32, 4/32
B and 4/64 SAN Switch models use t wo power cords.
The 4/8 and 4/16 SAN Switches use one power cord.
0015b
!
IO
I
O
I
A
TT
EN
T
IO
N
:
M
ax
imu
m screw l
ength
for
ra
ck
mou
nting
to
be
5m
m
or 13
/64
in.
Figure 21 Connecting the power cord
NOTE:
To protect against AC failure on the 4/32, 4/32B and 4/64 SAN Switch
models, connect each power cord to outlets on separate circuits. Verify
that the cords have a minimum service loop of 6 -inches to avoid stress.
2. To power on, set the two AC switches to the ON position (I).
IMPORTANT:
The 4/8 and 4/16 SAN Switches utilize one power switch. The 4/32,
4/32B and 4/64 SAN Switches utilize two power switches.
The power supply LED lights green and the switch runs the power-on self test (POST) .
The sw itc h requires at least three minutes to boot and complete PO ST.
3. After POST and the boot process are completed, verify that the System Status and
System P ower LEDs light green.
56
Installing and configuring SAN Switches