Filter
Top Products
96 Hardware Maintenance Manual: xSeries 220
Ethernet port connector
The following table shows the pin-number assignments for the RJ-45 connector. These
assignments apply to both 10BASE-T and 100BASE-TX devices.
If you plan to use the Wake on LAN function in the server, you must install a Wake on
LAN-enabled Ethernet NIC adapter in PCI slot 1, and use the Ethernet cable that
comes with the Ethernet adapter to connect the Ethernet adapter to the system board.
For additional information on the Wake on LAN function, adapters and cables, refer
to the documentation that comes with the Ethernet adapters.
The following table shows the pin-number assignments for the Ethernet Wake on
LAN PCI adapter power connector.
Pin Signal Pin Signal
1+Transmit data 5Not connected
2-Transmit data 6-Receive data
3+Receive data 7Not connected
4 Not connected 8 Not connected
Table 16. Ethernet RJ-45 connector pin-number assignments.
Pin Signal
1+5 AUX
2Ground
3 Not connected
Table 17. Wake on LAN PCI adapter power connector pin-number
assignments.