Filter
Top Products
50 Hardware Maintenance Manual: xSeries 220
16. To install the new system bezel that comes with the conversion kit, align the tab
on the back of the bezel with the tab opening on the left-front of the system; then,
swing the bezel toward the system and press until it snaps into place.
Figure 14. Installing the new system bezel
17. Install the release-latch-bracket assemblies on the system.
a. Align the bracket marked with an L with the holes on the left side of the
system; then, use two M3.5 screws to attach the bracket to the system.
Figure 15. Installing the release-latch-bracket assemblies
b. Repeat this step to install the other release-latch-bracket assembly on the right
side of the system.
Release-latch-bracket assembly