IBM XSERIES 220 Computer Hardware User Manual


 
General information 9
The Wake on LAN feature is enabled in the Configuration/Setup Utility
program.
A supported Wake on LAN adapter is installed in PCI slot 1 and is connected
to the system board with the 3-pin auxiliary power connector.
Notes:
1. See “Choices available from the Configuration/Setup main menu” on page 30
for a description of the Configuration/Setup Utility program.
2. See “System board options connectors” on page 55 for connector locations.
3. For additional information on the Wake on LAN function, adapters, and
cables, refer to the documentation that comes with the adapters.
4. See “Ethernet port” on page 93 for information on Ethernet controllers and
adapters, and Wake on LAN PCI adapters.
If the optional system-management adapter is installed in your server, the
system-management adapter can turn on the server.
Turning off the server
You can turn off the server in any of the following ways:
You can press the power-control button on the top of the server. This starts an
orderly shutdown of the operating system, if this feature is supported by your
operating system.
Note: After turning off the server, wait at least five seconds before you press the
power-control button to turn on the server again.
You might need to press and hold the power-control button for more than four
seconds to cause an immediate shutdown of the server and to force the power off.
You can use this feature if the operating system stops functioning.
You can disconnect the server power cords from the electrical outlets to shut off
all power to the server.
Note: After disconnecting the power cords, wait approximately 15 seconds for
your system to stop running. Watch for the power-on light to stop
blinking.
CAUTION:
The power control button on the device and the power switch on the power supply do not
turn off the electrical current supplied to the device. The device also might have more than
one power cord. To remove all electrical current from the device, ensure that all power
cords are disconnected from the power source.