Filter
Top Products
104 Hardware Maintenance Manual: xSeries 220
6. Gently slide the floppy disk drive toward the rear of the server and lift it out.
Bezel release latch
Before you begin:
• Read “Safety information” on page 133.
• Review the information in “Before you begin” on page 58.
To remove the bezel release latch, do the following:
1. Power-off the server, if it is on.
2. Unplug the server.
3. Remove the cover (see “Removing the side cover” on page 59).
4. Remove the front bezel (see “Removing the bezel” on page 60).
5. Remove the handle assembly (see “Handle assembly” on page 105).
6. Remove the top/side cover (see “Top/side cover”).
7. Press down on the tab.
8. From the underside, grasp the bezel release latch in the center and gently pull it
back and away from the server.
Top/side cover
Before you begin:
• Read “Safety information” on page 133.
• Review the information in “Before you begin” on page 58.