Intel CM8062101038606 Computer Hardware User Manual


 
Power Management
94 Intel® Xeon® Processor E5-1600/E5-2600/E5-4600 Product Families
Datasheet Volume One
4.2.5 Package C-States
The processor supports C0, C1/C1E, C2, C3, and C6 power states. The following is a
summary of the general rules for package C-state entry. These apply to all package
C-states unless specified otherwise:
A package C-state request is determined by the lowest numerical core C-state
amongst all cores.
A package C-state is automatically resolved by the processor depending on the
core idle power states and the status of the platform components.
Each core can be at a lower idle power state than the package if the platform
does not grant the processor permission to enter a requested package C-state.
The platform may allow additional power savings to be realized in the
processor.
For package C-states, the processor is not required to enter C0 before entering any
other C-state.
The processor exits a package C-state when a break event is detected. Depending on
the type of break event, the processor does the following:
If a core break event is received, the target core is activated and the break event
message is forwarded to the target core.
If the break event is not masked, the target core enters the core C0 state and
the processor enters package C0.
If the break event is masked, the processor attempts to re-enter its previous
package state.
If the break event was due to a memory access or snoop request.
But the platform did not request to keep the processor in a higher package
C-state, the package returns to its previous C-state.
And the platform requests a higher power C-state, the memory access or snoop
request is serviced and the package remains in the higher power C-state.
The package C-states fall into two categories: independent and coordinated. C0/C1/
C1E are independent, while C2/C3/C6 are coordinated.
Starting with the 2nd Generation Intel(r) Core(TM) Processor Family, package C-states
are based on exit latency requirements which are accumulated from the PCIe* devices,
PCH, and software sources. The level of power savings that can be achieved is a
function of the exit latency requirement from the platform. As a result, there is no fixed
relationship between the coordinated C-state of a package, and the power savings that
will be obtained from the state. Coordinated package C-states offer a range of power
savings which is a function of the guaranteed exit latency requirement from the
platform.
There is also a concept of Execution Allowed (EA), when EA status is 0, the cores in a
socket are in C3 or a deeper state, a socket initiates a request to enter a coordinated
package C-state. The coordination is across all sockets and the PCH.
Table 4-9 shows an example of a dual-core processor package C-state resolution.
Figure 4-3 summarizes package C-state transitions with package C2 as the interim
between PC0 and PC1 prior to PC3 and PC6.