Filter
Top Products
User Manual 107
English
SNMP Settings Configuring the SNMP
Trap community
Type in the trap community name. The
trap community name can be up to 15
alphanumeric characters long.
Trap IP Address
Type in the trap IP address. If the IP
address is 0.0.0.0, a trap will not be issued.
SysContact
Set the MIB-II SysContact (manager
name). The manager name can be up to
78 alphanumeric characters long.
SysName
Set the MIB-II SysName (product name).
The product name can be up to 78
alphanumeric characters long.
SysLocation
Set the MIB-II SysLocation (installation
location). The installation location can
be up to 78 alphanumeric characters long.
Default TTL
Set the IP packet lifetime (TTL value).
The value set should be between 0 and
255 seconds.
Enable AuthenTrap
Determine whether to enable or disable the
authentication violation trap.
To enable set “Enable” and to disable set
“Disable”.
Printer Trap Category
Printer Trap Community Name
Set with up to 71 alphanumeric characters long.
Protocol Address
TCP #n
Type in the trap IP address in the case of
TCP/IP. Up to 5 addresses can be set. If the
value typed is “0.0.0.0”, a trap will not be
issued.
IPX
Type in HEX as the trap IP address in the
case of IPX. Only 1 address can be set. If
you type in “00000000:000000000000”,
a trap will not be issued.
Trap Type
Determine if each of the Trap Enable, Online,
Offline, Paper Out, Paper Jam, Cover Open and
Printer Error will be used or not.
MIB-II category
Authentic community
Set the authentic community name. The
authentic community name can be up to
15 alphanumeric characters long.
7100e+.p65 25/08/99, 20:52 PM107