Filter
Top Products
User Manual 133
English
Using setup utility (Macintosh)
It is possible to set up the Fast EtherNet from a Macintosh running
TCP/IP, using the Setup Utility for Macintosh that comes with
the Fast EtherNet.
Operating environment
A Macintosh using System 7.1.2 or later, running TCP/IP.
• This Setup Utility does not operate on a Macintosh
with an operating system earlier than System 7.1.2.
• TCP/IP is required also for Macintosh. Select [TCP/
IP] in Control Panels to set each address. Instead of
[TCP/IP], there may be [MacTCP] in Control Panels,
depending on the OS version. For details, see your
Macintosh manual.
Setting up and using the utility
Please have the “Fast EtherNet CD-ROM” ready. The following
procedure uses MacOS8.5 as an example.
1 Insert the “Fast EtherNet CDROM” into the Macintosh.
Double-click [Setup Utility] in [Mac] - [ENGLISH] folder.
It may also be copied onto the Macintosh hard disk
and double-clicking to start it up.
2 Click [OK]. After searching for Fast EtherNets, a result list
will be displayed.
7100e+.p65 25/08/99, 20:55 PM133