Filter
Top Products
Fast Ethernet
7100e+
42
9. Configure the TCP/IP Tab item and make the following
“Settings”.
10. If the settings are all correct, click on “Setup”. The values
set are transmitted to the Fast EtherNet after clicking on
“Yes”.
At this point, however, the Fast EtherNet operates on
the pre-transmission values set.
➊ Check the “Use the TCP/IP protocol”.
➋ Type in the “IP address”.
➌ Uncheck the “Use RAPP” and “Use DHCP/BOOTP”.
In the case that the IP address is obtained from the
RARP server, DHCP server or BOOTP server, check
in accordance with the network environment.
In the case that no server exists, you must uncheck or
severe damage may be caused to the network
➍ Type in the “Subnet mask”.
➎ Type in the “Gateway address”.
11. In order to validate the values set, click on “Yes”.
12. Select “Exit” in the “File” menu and close the
AdminManager. Next, click on “Exit” in the Setup Utility
to quit the Setup Utility. Utility to exit the Setup Utility.
➊
➋
➌
➍
➎
7100e+.p65 25/08/99, 20:50 PM42