Filter
Top Products
User Manual 109
English
Using TELNET
The Fast EtherNet can be configured using the TELNET related
to the workstation.
· In order to change the Fast EtherNet configuration,
the user must login as “root”.
· The factory setting of the password of the “root” user
is “None”.
· If you type in a wrong IP address the network may go
down or other severe damage may occur. Set the
configuration only after consulting your network
manager.
In the following explanation, SunSolaris2.4 is used as an
example. The method of configuring each command may differ
from one workstation to another. Refer to your workstation’s
manual.
1. Log in as root on the workstation.
If it is not possible to log in with super-user
authorization, leave the configuration to the network
manager.
2. Using the APR command, set a temporary IP address on the
Fast EtherNet.
Example: If the IP address is “192.168.20.127” and the Fast
EtherNet address is “00:80:92:01:00:D2” [then enter]
# arp s 192.168.20.127 00:80:92:01:00:D2 temp
The EtherNet address (MAC Address) is displayed in
the print menu of the printer. If an IP address was
already set in the Fast EtherNet, there is no need to
set a temporary address using the ARP command.
3 Use the ping command to confirm the connection with the
Fast EtherNet.
Example: If the IP address is “192.168.20.127”, [type]
#ping 192.168.20.127
If there is no reply, then there is a problem with the IP
address configured under Step 2 or with the
condition of the network. Consult your network
manager.
7100e+.p65 25/08/99, 20:52 PM109