Filter
Top Products
Fast Ethernet
7100e+
152
Printer preparation
In order to use DHCP, BOOTP or RARP, you need to set DHCP/
BOOTP or RARP to ENABLE on the Fast EtherNet. Use one of
the following procedures to set up the Fast EtherNet.
Setting from utility
This section describes how to set up with the Standard Setup
Utility for Windows. You can also use the Setup Utility for
Macintosh, TELNET, etc., for this setting. Use the utility suitable
for the environment of your network, referring to the following
explanation.
The description begins at the point where the Standard Setup
Utility has been started. For setting up the utility, refer to Chapter
7 Control of Fast EtherNet.
1 Referring to the Ethernet address, select the Fast EtherNet to
be configured from the list.
The Ethernet address appears on the self-diagnostics
test print for the Fast EtherNet
2 Select [OKI Device Setup] in the [Settings] menu.
7100e+.p65 25/08/99, 20:55 PM152