Filter
Top Products
User Manual 151
English
Main Specifications
Item Content
CPU Falcon 33MHz
Network Interface 100BASE-TX
10BASE-T
Network protocols IPX/SPX (NetWare)
Remote printer mode
Print server mode
Frame types: IEEE802.2, IEEE802.3,
Ethernet-II, SNAP
EtherTalk
DDP, NBP, AEP, TRMP, ATP, PAP,
ZIP, AppleTalk phase2
TCP/IP
FTP, LPD, TELNET, ARP, DHCP,
BOOTP, RARP, ICMP, SNMP, HTTP
NetBEUI
SMB, NetBIOS
Functions Banner print function (FTP, LPD)
Kanji filter function (FTP, LPD)
IP Address Configuration Using DHCP, BOOTP,
RARP
This Ethernet board supports DHCP, BOOTP, and RARP and
can dynamically acquire its IP address at start-up. You must
however have a DHCP, BOOTP or RARP server on your network
to use this functionality.
Before configuration
In order to configure the DHCP server, BOOTP server or RARP
server, there must be a super-user. If you do not have a super-
user authorization, leave the configuration to the network
manager.
· Cannot be used if there is no DHCP server, BOOTP
server or RARP server on the network.
· If you type in a wrong IP address the network may go
down or other severe damage may occur. Set the
configuration only after consulting your network
manager.
7100e+.p65 25/08/99, 20:55 PM151