Filter
Top Products
September 2000 2-1
2 Using the System
This chapter explains how to use the KODAK PROFESSIONAL LED II Printer
20R. It takes you from startup to shutdown. Topics include:
Starting up the Printer ........................................................................................2-1
Calibrating the Printer ........................................................................................2-2
Obtaining Densities .....................................................................................2-4
Completing the Calibration ..........................................................................2-6
Making Prints .....................................................................................................2-7
Shutting Down the Printer ..................................................................................2-8
Soft Shutdown..............................................................................................2-8
Hard Shutdown ...........................................................................................2-9
Starting up the Printer
1. If needed, turn the circuit breaker on the back of the printer on.
2. Press the Start key on the OCP to begin the printer initialization process.
If paper is loaded, when initialization is complete (3 to 4 minutes) the
message “Status: ON LINE - Ready” appears on the OCP. Startup is complete
and the printer is ready to print. Turn the host computer on; then go to the next
page and calibrate the printer.
If paper is not loaded, the message “Out of paper, open supply door
to load” appears on the OCP. Do the procedures below.
• “Loading Paper Into the Supply Cassette” on page 3-6
• “Installing the Takeup Cassette” on page 3-14
When “On-line and Ready” is displayed, turn the host computer on. Go to
the next page and calibrate the printer.