Filter
Top Products
Diagnostics and Troubleshooting
5-16 September 2000
111 There is insufficient memory
for the requested operation
on device:_devicename_.
The application does not have
enough memory to complete the
operation.
Close the other applications and
unnecessary windows.
112 A communications time-out
occurred during operation on
device:_devicename_.
The connection between the
printer and host computer was
lost.
Check that all of the cables are
properly connected.
113 A device driver for the
following device could not be
found:_devicename_.
The application could not find the
necessary device software to
communicate with the printer.
Make sure that the Calibration
Application and ASPI SCSI device
driver are installed correctly.
114 An error occurred during
communications to the
following device:
_devicename_.
• The cable between the printer
and the host computer is worn.
• One or more of the
connections between the
printer and the host computer
has malfunctioned.
• Check that all of the cables are
properly connected.
• Check the cables and
connections between the printer
and the host computer for wear
and if necessary, replace them.
115 An operation error occurred
during communications to
the following device:_
devicename_.
• The cable between the printer
and the host computer is worn.
• One or more of the
connections between the
printer and the host computer
has malfunctioned.
• Check that all of the cables are
properly connected.
• Check the cables and
connections between the printer
and the host computer for wear
and if necessary, replace them.
116 A software warning has been
issued by the following
device: _devicename_ Error
Message: _errmsg_
A software error has occurred on
the printer.
Resolve printer error condition.
117 A software error has been
detected by the following
device: _devicename_ Error
Message: _errmsg_
An error has occurred on the
printer.
Resolve printer error condition.
118 A SCSI ID for the following
device was not found:
_devicename_.
SCSI driver not found. Reinstall SCSI driver on host
computer.
119 The wrong SCSI ID was
specified for the following
device: _devicename_.
SCSI ID is incorrect. Set Target SCSI ID to printer SCSI
ID.
120 This device has been setup
for the wrong model of
printer: _devicename_.
Device chosen has not been
found.
Verify device chosen matches the
printer model.
121 Unable to read STATUS from
device: _devicename_.
Unable to see the printer. Check SCSI cable connections.
122 The selected LUT contains
data that exceeds the limits
of this printer.
Trying to send a 12-bit LUT to a
10-bit printer.
Select a 10-bit LUT file.
201 An error occurred while
trying to allocate memory.
The system is trying to allocate
memory, however, no memory is
available.
Close any unnecessary
applications.
Error
Code
Error Code /Status
Message
Possible Cause/Subsystem Possible Solution