Kyocera KM-C2525E All in One Printer User Manual


 
xiii
Installation Precautions
Environment
Caution
Avoid placing the machine on or in locations which are unstable or not level. Such
locations may cause the machine to fall down or fall over. This type of situation presents
a danger of personal injury or damage to the machine.
Avoid locations with humidity or dust and dirt. If dust or dirt become attached to the
power plug, clean the plug to avoid the danger of fire or electrical shock.
Avoid locations near radiators, heaters, or other heat sources, or locations near
flammable items, to avoid the danger of fire.
To keep the machine cool and facilitate changing of parts and maintenance, allow access
space as shown below. Leave adequate space, especially around the rear cover, to allow
air to be properly ventilated out of the machine.
Other precautions
The service environmental conditions are as follows:
Temperature: 50 to 90.5 °F (10 to 32.5 °C), but humidity should be 70 % or less when
temperature is 90.5 °F (32.5 °C)
Humidity: 15 to 80 %, but temperature should be 86 °F or less (30 °C or less) when humidity
is 80%
However, adverse environmental conditions may affect the image quality. It is recommended to
use the machine at a temperature: around 60.8 to 80.6 °F (16 to 27 °C), humidity: around 36 to
65 %. In addition, avoid the following locations when selecting a site for the machine.
Avoid locations near a window or with exposure to direct sunlight.
Avoid locations with vibrations.
Avoid locations with drastic temperature fluctuations.
Avoid locations with direct exposure to hot or cold air.
Avoid poorly ventilated locations.
19 11/16"
50 cm
11 13/16"
30 cm
39 3/8"
100 cm
3 15/16"
10 cm