Filter
Top Products
• Touch Reset active bin to reset the active bin for a linked set of bins.
• Cancel the print job.
Change [paper source] to [paper type] [paper size] load [orientation]
Try one or more of the following:
• Load the correct size and type of paper in the tray or feeder, specify the paper size and type in the Paper menu on
the control panel, and then touch Finished changing paper.
• Touch Use current [paper source] to use the available paper size and type in the tray.
• Touch Reset active bin to reset the active bin for a linked set of bins.
• Cancel the print job.
Close door [x]
Close the specified door.
Complex page, some data may not have printed [39]
Try one or more of the following:
• From the control panel, touch Continue to clear the message and continue printing.
• Touch Reset active bin to reset the active bin for a linked set of bins.
• Cancel the print job.
• Install additional printer memory.
Configuration change, some held jobs were not restored [57]
Held jobs are invalidated because of the following possible changes in the printer:
• The printer firmware has been updated.
• The tray for the print job has been removed.
• The print job is sent from a flash drive that is no longer attached to the USB port.
• The printer hard disk contains print jobs that were stored when the hard disk was installed in a different printer
model.
From the printer control panel, touch Continue to clear the message.
Defective flash detected [51]
Try one or more of the following:
• Replace the defective flash memory card.
• From the printer control panel, touch Continue to ignore the message and continue printing.
• Cancel the current print job.
Troubleshooting 272