Filter
Top Products
• Update the network firmware in the printer or print server. For more information, visit the Lexmark support Web
site at
http://support.lexmark.com.
Not enough free space in flash memory for resources [52]
Try one or more of the following:
• From the control panel, touch Continue to clear the message and continue printing.
• Touch Reset active bin to reset the active bin for a linked set of bins.
• Delete fonts, macros, and other data stored in the flash memory.
• Install a flash memory card with larger capacity.
Note: Downloaded fonts and macros not previously stored in the flash memory are deleted.
Open door H and remove paper from beneath area H10
Remove the paper from the specified area.
Paper changes needed
Try one or more of the following:
• Touch Use current supplies to clear the message and continue printing.
• Cancel the current print job.
Parallel port [x] disabled [56]
Try one or more of the following:
• From the printer control panel, touch Continue to clear the message.
• Enable the parallel port. From the printer control panel, navigate to:
Network/Ports > Parallel [x] > Parallel Buffer > Auto
Note: The printer discards any data received through the parallel port.
Photoconductor low [84.xy]
You may need to order a replacement photoconductor. If necessary, select Continue on the control panel to clear the
message and continue printing.
Photoconductor very low [84.xy]
You may need to replace the photoconductor unit very soon. For more information, see “Replacing a photoconductor
unit” on page 213.
If necessary, touch Continue on the control panel to clear the message and continue printing.
Troubleshooting 279