Filter
Top Products
4 Remove the hard disk.
Installing hardware options
Order of installation
CAUTION—POTENTIAL INJURY: The printer weight is greater than 18 kg (40 lb) and requires two or more
trained personnel to lift it safely.
CAUTION—TIPPING HAZARD: Floor-mounted configurations require additional furniture for stability. You must
use either a printer stand or printer base if you are using multiple input options. If you purchased a
multifunction printer (MFP) that scans, copies, and faxes, then you may need additional furniture. For more
information, see
www.lexmark.com/multifunctionprinters.
CAUTION—SHOCK HAZARD: If you are accessing the controller board or installing optional hardware or
memory devices sometime after setting up the printer, then turn the printer off, and unplug the power cord
from the electrical outlet before continuing. If you have any other devices attached to the printer, then turn
them off as well, and unplug any cables going into the printer.
Install the printer and any options you have purchased in the following order:
• Optional 2 x 500‑ or 2500‑sheet tray
• Printer
• Staple finisher
Note: This option is supported only in select printer models.
• Staple, hole punch finisher or booklet finisher
• Optional 3000‑sheet tray
Note: The staple finisher is not supported if another finisher is installed. For more information on installing the
finishers and optional trays, see the instruction sheet that came with the option.
Installing optional trays
Notes:
• For information on installing the optional 3000-sheet tray, see the instruction sheet that came with the option.
• Use the screwdriver located inside the bottom front door of the printer.
Additional printer setup 38