Filter
Top Products
Printer had to restart. Last job may be incomplete.
From the printer control panel, touch Continue to clear the message and continue printing.
For more information, visit
http://support.lexmark.com or contact customer support.
Reinstall missing or unresponsive cartridge [31.xy]
Try one or more of the following:
• Check if the toner cartridge is missing. If missing, install the toner cartridge.
For information on installing the cartridge, see the “Replacing supplies” section of the User’s Guide.
• If the toner cartridge is installed, then remove the unresponsive toner cartridge, and then reinstall it.
Note: If the message appears after reinstalling the supply, then the cartridge is defective. Replace the toner
cartridge.
Reinstall missing or unresponsive photoconductor [31.xy]
Try one or more of the following:
• If the photoconductor unit is missing, then install it. For more information, see “Replacing a photoconductor unit”
on page 213.
• If the photoconductor unit is installed, then remove and then reinstall it.
Note: If the message appears after reinstalling the supply, then replace the defective photoconductor unit.
Remove defective disk [61]
Remove and replace the defective printer hard disk.
Remove packaging material, [area name]
Remove any remaining packaging material from the specified location.
Remove packaging material, open door C, remove metal clips, remove all screws
from scanner carriage
Open door C and the scanner cover, and then remove any remaining packaging material.
Note: Make sure door C does not hit any cable attached to the printer.
Remove paper from all bins
Remove the paper from all of the bins. The printer automatically senses paper removal and resumes printing.
If removing the paper does not clear the message, then touch Continue.
Troubleshooting 280