Filter
Top Products
Selecting an output location
30
Selecting an output location
The machine has two output locations; the front output tray and the rear output slot.
Front output tray
The front output tray should be used to output plain paper only. You should use the rear output slot
for envelopes, labels, small custom-sized paper, postcards, and transparencies. To use the front
output tray, make sure the rear cover is closed.
Paper is output facedown into the front output tray, with the last page on the bottom. This tray should
be used for most jobs and is recommended for jobs requiring over 50 sheets of plain paper
continuously.
Note: If problems, such as excessive curl, occur when using the front output tray, try using
the rear output slot.
Rear output slot
You can use the rear output slot for all paper types, however, for envelopes, labels, small
custom-sized paper, postcards, and transparencies using this slot is recommended. To use the rear
output slot, open the rear cover.
Paper is output faceup through the rear output slot, with the last page on the top. To avoid paper
jams, do not open or close the rear cover while printing.
CAUTION: The fuser area is hot. Avoid contact with the fuser area to prevent burns.
Rear output
slot
Front output
tray