Filter
Top Products
Customizing default settings
48
Customizing default settings
The default settings for the basic copy options (darkness, content, number, scale) are set using the
operator panel menu. When you copy a document, these default settings are used unless you
change them using the operator panel buttons (see page 45).
To customize the default settings:
Press Menu.
3 Press a scroll button ( ) until COPY MENU appears on the top line of the display, and
then press Select.
4 Press a scroll button to scroll through the copy options.
5 When the option you want to change appears, press Select.
6 Change the setting by pressing a scroll button or enter a value using the numeric keypad,
and then press Select.
7 Repeat steps 4 through 6, as necessary.
Note: While setting copy options, pressing Stop/Clear cancels the changed setting and
restores the default status.
8 To return to the Ready prompt, press Stop/Clear.
Setting the Timeout option
If you change your copy settings using the operator panel buttons for a specific job, your machine will
eventually restore your default settings.
To set the length of time the machine waits before restoring default settings:
1 Press Menu.
2 Press a scroll button ( ) until MACHINE SETUP appears on the top line of the display, and
then press Select.
3 Press a scroll button until TIMEOUT appears on the bottom line of the display, and then press
Select.
4 Press a scroll button until the status you want (15, 30, 60, or 180 seconds) appears on the
display, and then press Select.
5 To return to the Ready prompt, press Stop/Clear.
or
or