Filter
Top Products
201 paper jam
1 Open the upper front door, and then open the lower front door.
Warning—Potential Damage: To avoid overexposing the photoconductors, do not leave the front doors open
for more than 10 minutes.
CAUTION—HOT SURFACE: The inside of the printer might be hot. To reduce the risk of injury from a hot
component, allow the surface to cool before touching.
2 Determine where the jam is located, and then remove it:
a If paper is visible under the fuser, then grasp it on each side and pull it forward.
b If paper is not visible, then you will need to remove the fuser unit.
Warning—Potential Damage: Do not touch the center of the fuser unit. Doing so may cause your fingers
to touch the roller underneath the fuser unit. Touching the fuser roller will damage the fuser.
1 Turn the screws on the fuser to the left to loosen them.
2 Lift the handholds on each side of the fuser, and then pull forward to remove it.
3 Remove the jammed paper.
Troubleshooting
266