Filter
Top Products
Procedure: Software Installation
Issue 5 June 1999
2-5
Figure 2-4. Wireless-Related System Parameters Form (G3si/vs/Prologix
™
)
7. Allow the administrable part of the
System Identification
field to remain at the default
value of 2176.
NOTE:
This field provides the system with an identifier that is broadcast
regularly in its beacon or traffic-bearing channels. The system ID
includes two parts: system-generated digits and administrable digits.
The system-generated part is displayed as a read-only prefix to the
administrable part.
If this field is changed, you must busy out, reset, and release the RC
before the change will be read into the RC.
8. In the
Maximum Radio Controllers
field, enter the maximum number of RCs that
may be administered in the system. This number is based on the UTAM clearance
for the site from the DWDT, and it should match the number of RCs designated in
the DWDT package. UTAM clearance from the DWDT and the DWDT package
are required for DWBS activation in the United States. Valid values for the field
are from 0 to 50 inclusive.
NOTE:
The field determines the number of RCs that are added to the system via the
add radio-controller command. The field does not limit the number of RC
WIRELESS-RELATED SYSTEM PARAMETERS
System Identification: 0100015-2176
change system-parameters wireless
Allowable Carrier Frequencies (MHz)
0: 1929.375
y
Master Port Network: 1
1: 1928.125
y
2: 1926.875 y
3: 1925.625
y
4: 1924.375 y
5: 1923.125
y
6: 1921.875 y
7: 1920.625 y
Radio Transmission: y
Maximum Radio Controllers: 10
Maximum Wireless Terminals: 200
Port Networks With Radio Controllers
1:
y
2: n
3: n
Page 1 of 1
UTAM Disablement? y