Filter
Top Products
Procedure: Software Installation
Issue 5 June 1999
2-7
NOTE:
The eight field options support the administration of the superset of
carrier frequencies that are allowed for a system as determined by
UTAM. (UTAM has been designated by the FCC as a frequency
coordinator for the unlicensed band.) The allowable carrier
frequencies administered in this field define the frequencies that can
be administered in the Carrier-Frequencies form.
If this field is changed, you must busy out, reset, and release the RC
before the change will be read into the RC.
13. Enable all port networks that will contain RC circuit packs by updating the
specific field value to y.
NOTE:
RCs that are serving contiguous areas must be in the same port
network.
During a power-up system reset, the
Radio Transmission
field is set
to n and wireless capabilities are disabled until Lucent Technologies
can verify that the system has not been moved. Refer to Chapter 1 of
this document for details.
14. Submit the completed form.
15. Execute the change carrier-frequencies command to administer the
carrier frequencies.
NOTE:
All frequencies that are administered as y on the System-Parameters
Wireless form are also defaulted to y on the Carrier-Frequencies
form. This form must be changed only if the customer is not going to
use a frequency that has been approved for use by the FCC.
If this field is changed, you must busy out, reset, and release the RC
before the change will be read into the RC.