Filter
Top Products
Hardware Installation
3-54 Issue 5 June 1999
5. Insert the WT with its battery pack into the battery charger cradle.
6. Plug the AC adapter from the battery charger into a wall outlet.
7. Ensure that the initial charging lasts for four hours before using the WT.
Procedure: Obtaining the IPEI and Entering
Access Codes for the WTs
This procedure provides the steps to display the IPEI of the WT and enter the
access code for the WTs. This procedure is required for all new and replacement
WTs.
For the 9601 WT, do the following:
1. With the WT powered up, press .
2. At the next display, press .
3. At the following display, press the info soft key; the IPEI is displayed.
4. Enter the IPEI into the Station form. To access the form, enter the add
station or change station command.
5. Reseat the battery. The WT should display icons and be ready for use.
For the 9630 Series WT, do the following:
1. With the WT powered up, press .
2. At the next display, press four times.
NOTE:
Instructions for checking and downloading WT firmware are included in the
next chapter.
Menu
Next
Menu
Next