Filter
Top Products
Safety Information
Issue 5 June 1999
3-3
■ Do not use the product near water or when you are wet. If the product
comes in contact with any liquids, unplug the power cord and WT line cords
immediately. Do not plug the product back in until it has dried thoroughly.
■ If you suspect a gas leak, report it immediately, but use a WT away from
the area in question. The WT’s electrical contacts could generate a tiny
spark. While unlikely, it is possible that this spark could ignite a heavy
concentration of gas. This product is not approved for use in areas
identified by the Occupational Safety and Health Administration (OSHA) as
explosive environments. Only
Explosive Atmosphere WTs
may be used in
such hazardous environments.
■ Install this product securely on a stable surface. Damage may result if the
product falls.
■ Use only the correct power source. If you are not sure of the power supply
to your location, consult your local power company.
■ Use only the Model #DV-9500 power supply shipped with this product for
the charging cradle.
■ The CAU must be installed with the coaxial cable provided (comcode
847565132). DO NOT cut or modify the cable. Loop any excess cable in
the ceiling.
NOTE:
Do not kink or crush the coaxial cable.
■ Install this product in a protected location where no one can step on or trip
over power cords and WT line cords. Do not place objects on the cords that
may cause damage or abrasion.
■ Whenever possible, install -48v power supplies in the switch room or wiring
closets.
■ Do not allow anything to rest on the power cord. Do not locate this product
where the cord will be damaged by persons walking on it. Do not overload
wall outlets; this can result in fire or electric shock. Do not staple or
otherwise attach the power cord to building surfaces.
■ Slots and openings in the WFB and CAU are provided for ventilation. To
protect the housing from overheating, these openings must not be blocked
or covered. Also, do not place this product in an enclosed area unless
proper ventilation is provided.
■ Never push objects of any kind into this product through housing slots
since the objects may touch hazardous voltage points or short out parts
that could result in a risk of electric shock. Never spill liquid of any kind on
the WT.
■ Never place this product near or over a radiator or heat register.
■ Use only the type of battery pack shipped with this product.