Filter
Top Products
Switch Administration
2-6 Issue 5 June 1999
circuit packs that may be physically inserted into and recognized by the
system.
9. Enter the maximum number of WTs that are in the system. This number is based on
the order of rights-to-use (RTUs) per station. Valid values are from 0 to 1500
inclusive.
NOTE:
The number of administered WTs is included in the system-wide count of
station and trunk ports administered in the
Maximum Ports
field within the
Customer-Options form. The value in the
Maximum Wireless Terminals
field
must always be less than or equal to the value in the
Maximum Ports
field.
10. Set the
Master Port Network
field to a number identifying a port network
that contains an RC circuit pack. Values for a G3si system include 1, 2, and
3. Values for a G3r system include 01 through 44. The default value is a
blank field.
NOTE:
This field is displayed only for DEFINITY ECS G3i and DEFINITY
ECS G3r configurations.
11. Populate the
UTAM Disablement
field, as desired. This field is used to
control whether the UTAM disablement feature is active for a system (that
is, whether the DWBS disables itself following a system power cycle).
Default is y. This means that, as a default, the radio subsystem is disabled
following a power cycle of the system. Whenever a DWBS is power-cycled,
the
Radio Transmission
field is set to n, and the radios are disabled. A save
translations is done on the system, and a major alarm is activated for the
system over the Initialization and Administration System (INADS) line.
INADS is set up to log into the DEFINITY ECS and set the
Radio
Transmission
field to y to restore radio service.
Whenever the field is set to n, the radio subsystem is not disabled following
a system power cycle. This means that, after a power cycle, the
Radio
Transmission
field is not set to n, a save translations is not done, a major
alarm is not generated, and a call into the DEFINITY ECS is not required to
restore radio service. The radio subsystem continues to initialize and
operate as normal.
On system upgrades, value y is the default for the field.
NOTE:
This field should be changed to n only whenever the DWBS resides
in countries where the legal requirements for disablement do not
apply.
12. In the
Allowable Carrier Frequencies
field, enable all frequencies by
updating the specific field value to y unless otherwise directed by the
DWDT.