Filter
Top Products
Level one function Level two function Level three function Summary of setting Default setting Page
2. User Settings 2.Fax Settings 01.Scan Parameters You can set the following settings for send fax message.
• Primary document mode Normal
• Primary contrast mode Normal 4.1
02.Print Parameters You can set the following settings for receive fax message.
• Reduction rate Auto
• Reduction margin 40 mm 4.3
• Half-page reception Off
03.Number of Rings Number of rings before your machine answers. 2 times 4.4
04.Redial Number of times and interval for automatic fax redialing. 2 times 4.5
1 minute
05.Dialing Pause Dialing pause length. 2 seconds 4.5
06.Memory Tx On/Off setting for Memory transmission. On 4.2
07.Quick Tx On/Off setting for Quick Memory transmission. On 4.2
08.TTI Tx On/Off setting for sending your TTI. On 4.2
09.ECM Mode On/Off setting for ECM mode. On 4.1
10.Block Junk Fax Reject the fax reception from unauthorized incoming faxes. Off 3.45
11.Security Rx Keep all received fax messages in memory and after print them. Off 3.42
12.Separator Page Partition each received documents by inserting the separator page. Off 3.21
13.PIN Mode Prevent unauthorized long-distance calls. Off 3.43
14.DRD Set the ring pattern to use with phone company’s Distinctive Ring
Off 3.22
service.
3.Copy Settings 1.Scan Parameters You can set the following settings for copying.
• Primary document mode Fine
• Primary contrast mode Normal
4.6
2.Print Parameters You can set the following settings for copying.
• Reduction rate 100%
• Reduction margin 24 mm
4.7
• Bypass Tray priority Off
4.Printer Settings*
3
1.TCP/IP Enter the IP Address, Subnet mask and Gate way address. — —
5.Scanner Settings*
4
1.Scan Parameters Enter the scanning parameters. — —
2.Auto Reset Set the time (minutes) for resetting the scan parameters and .
3 minutes —
returning to the Fax mode.
1.14
Getting started
*3: This option appears only if the optional NIC (network interface card) has been installed.
*4: This option appears only if the optional printer controller has been installed. For details see the operating instructions included with the printer controller kit.