Filter
Top Products
Advanced features
10
Press
ENTER
. The
LCD
shows:
Note: If there isn’t a password for this box, skip to step 12.
11
Use the numeric keypad to enter the appropriate
ITU
-
T
password for the box.
12
Press
ENTER
. The
LCD
shows:
13
Use the numeric keypad to enter the number exactly as your machine should
dial it, including whatever codes your phone system requires. The number can
be up to 40 characters in length.
Your display can show only 20 characters at a time. To view characters beyond
those 20, press to scroll to the left or to scroll to the right.
14
If you want the transmission to begin immediately every time you press the
key, press
ENTER
and proceed to step 15.
If you want to delay the transmission, follow steps 7–9 on page 3.33. Then
press
ENTER
,
ENTER
.
15
The
LCD
now asks if you want to make additional settings for this program-
mable one-touch number.
If you do not want to make additional settings, select “Off” and press
ENTER
.
Then skip to step 17.
If you do want to make additional settings, press to select “On” and press
ENTER
.
16
Follow steps 13–25 on page 3.34.
17
Press
STOP
to return your machine to standby mode.
Programming F-Code polling
For this operation to work, two things must be true:
• The document which you’re polling must exist in the remote fax’s F-Code box (
ITU
-
T
standard sub-addressing/password box).
• You must know the remote fax’s
ITU
-
T
sub-address and password (if any) for each
box you want to poll.
To program an F-Code polling operating into a programmable one-touch key:
1
Press
MENU
,3,4,1,
ENTER
. The
LCD
shows the first empty programmable one-
touch number available:
2
Press or to select the programmable one-touch key in which you want to
store or change.
Note: You can select the one-touch key by pressing that key on the control
panel.
3
If you selected the empty programmable one-touch key, proceed to step 4.
If you selected the key already programmed and you want to change it, skip
to step 6.
Note: If your previous command for this key was a F-Code polling and you
want to keep this key programmed a F-Code polling, use these instruc-
tions to make changes. But if the previous command for this key was a
different command, you must first erase the stored command (see page
3.41) before programming the new one.
4
Press
ENTER
. The
LCD
shows:
5
Press or until “Communication” appears.
6
Press
ENTER
. The
LCD
shows:
7
Press
COMM
.
OPTIONS
four times. The
LCD
shows:
4.F-Code Polling
$$
/
##
/Enter
58:Fax#/Comm.Options
_
Type :Communication
$$
/
##
/Enter
Select Program No.
58:No Number Stored
Option :Off
$$
/
##
/Enter
58:Fax#/Comm.Options
_
Enter Password
_
3.37