Filter
Top Products
Advanced features
4
Press
ENTER
. The
LCD
shows:
5
Press or until “Communication” appears.
6
Press
ENTER
. The
LCD
shows:
7
Press
COMM
.
OPTIONS
twice. The
LCD
shows:
8
Press
ENTER
. The
LCD
shows:
9
Use the numeric keypad to enter the number exactly as your machine should
dial it, including whatever codes your phone system requires. The number can
be up to 40 characters in length.
Your display can show only 20 characters at a time. To view characters beyond
those 20, press to scroll to the left or to scroll to the right.
10
If you want the polling to begin immediately every time you press the key,
press
ENTER
and proceed to step 11.
If you want to delay the polling, follow steps 7–9 on page 3.33. Then press
ENTER
,
ENTER
.
11
Press
STOP
to return your machine to standby mode.
Programming an F-Code transmission
For this operation to work, two things must be true:
• You must know how the remote fax is using each F-Code box to which you’re
transmitting — for example, as a security box or a relay box. Different fax manu-
facturers may use slightly different terms, but the concepts are the same.
• You must know the remote fax’s
ITU
-
T
sub-address and password for each box to
which you want to transmit.
To program an F-Code transmission into a programmable one-touch key:
1
Press
MENU
,3,4,1,
ENTER
. The
LCD
shows the first empty programmable one-
touch number available:
2
Press or to select the programmable one-touch key in which you want to
store or change.
Note: You can select the one-touch key by pressing that key on the control
panel.
3
If you selected the empty programmable one-touch key, proceed to step 4.
If you selected the key already programmed and you want to change it, skip
to step 6.
Note: If your previous command for this key was a F-Code transmission and
you want to keep this key programmed a F-Code transmission, use
these instructions to make changes. But if the previous command for
this key was a different command, you must first erase the stored com-
mand (see page 3.41) before programming the new one.
4
Press
ENTER
. The
LCD
shows:
5
Press or until “Communication” appears.
6
Press
ENTER
. The
LCD
shows:
7
Press
COMM
.
OPTIONS
three times. The
LCD
shows:
8
Press
ENTER
. The
LCD
shows:
9
Use the numeric keypad to enter the
ITU
-
T
sub-address for the box to which
you want to send the document.
Enter Sub-Address
_
3.F-Code Tx
$$
/
##
/Enter
58:Fax#/Comm.Options
_
Type :Communication
$$
/
##
/Enter
Select Program No.
58:No Number Stored
58:Fax#/Comm.Options
_
2.Polling
$$
/
##
/Enter
58:Fax#/Comm.Options
_
Type :Communication
$$
/
##
/Enter
3.36