Nortel Networks 10BASE-T Switch User Manual


 
Using the Console Interface
309985-A Rev 00
3-9
Configurable
Column header for the user-configurable fields in this screen. The data displayed in this
column represents parameters that you can configure (or that are currently configured).
In Use
Column header for the read-only fields in this screen. The read-only data displayed in
this column represents data that is currently in use.
Last BootP
Column header for the read-only fields in this screen. The read-only data displayed in
this column represents data obtained from the last BootP reply received.
In-Band Stack IP
Address
The in-band
stack
IP address field.
Default Value 0.0.0.0 (no IP address assigned)
Range Four-octet dotted-decimal notation, where each octet is represented
as a decimal value, separated by a decimal point
In-Band Switch
IP Address
The in-band IP address of the BayStack 410-24T switch. This field is not required for the
operation of the stack. This field can not use the same IP address used for the stack.
Default Value 0.0.0.0 (no IP address assigned)
Range Four-octet dotted-decimal notation, where each octet is represented
as a decimal value, separated by a decimal point
Note:
When the IP address is entered in the In-Band IP Address field, and the In-Band
Subnet Mask field value is not present, the software provides an
in-use
default value for
the In-Band Subnet Mask field that is based on the class of the IP address entered in the
In-Band IP Address field.
In-Band Subnet
Mask
The subnet address mask associated with the in-band IP address shown on the screen
(see Note above). Network routers use the subnet mask to determine the network or
subnet address portion of a host’s IP address. The bits in the IP address that contain the
network address (including the subnet) are set to 1 in the address mask, and the bits
that contain the host identifier are set to 0.
Default Value 0.0.0.0 (no subnet mask assigned)
Range Four-octet dotted-decimal notation, where each octet is represented
as a decimal value, separated by a decimal point
Default Gateway
The IP address of the default gateway.
Default Value 0.0.0.0 (no IP address assigned)
Range Four-octet dotted-decimal notation, where each octet is represented
as a decimal value, separated by a decimal point
Table 3-2. IP Configuration/Setup Screen Fields
(continued)
Field Description