Filter
Top Products
Using the BayStack 410-24T 10BASE-T Switch
3-72
309985-A Rev 00
Renumber Stack Units
The Renumber Stack Units screen (Figure 3-28) allows you to renumber the units
configured in the stack.
When selected, this option identifies the unit number of each unit in the stack
configuration by lighting the corresponding number of port LEDs on each unit for
approximately 10 seconds. For example, unit 3 will display three LEDs.
Choose Renumber Stack Units (or press n) from the main menu to open the
Renumber Stack Units screen.
Figure 3-28. Renumber Stack Units Screen
Note:
This menu option and screen only appear when the switch is
participating in a stack configuration.
Renumber Stack Units
Current Unit Number MAC Address New Unit Number
------------------- ---------------------------- ---------------
[ 1 ] 00-60-fd-77-a6-0c [ 1 ]
[ 2 ] 00-60-fd-77-a5-f0 [ 2 ]
[ 3 ] 00-60-fd-77-a4-4c [ 3 ]
[ 4 ] 00-60-fd-77-ab-84 [ 4 ]
Renumbering stack units will cause an automatic Reset to Current Settings to
occur across the entire stack. The current configuration will be adapted to
the new numbering scheme. Check the stack configuration after the reset to
confirm the desired configuration is set.
Are you sure you want to renumber switches with the new settings? [ No ]
Use space bar to display choices, press <Return> or <Enter> to select choice.
Press Ctrl-R to return to previous menu. Press Ctrl-C to return to Main Menu.