![](http://pdfasset.owneriq.net/f/e5/fe5a490e-7029-4909-9b04-428aff7e02d4/fe5a490e-7029-4909-9b04-428aff7e02d4-bg107.png)
309985-A Rev 00
5-1
Chapter 5
Connectors and Pin Assignments
This appendix describes the BayStack 410-24T switch port connectors and pin
assignments.
RJ-45 (10BASE-T/100BASE-TX) Port Connectors
The RJ-45 port connectors (Figure 5-1) are wired as MDI-X ports to connect end
stations without using crossover cables. (See “
MDI and MDI-X Devices” on
page 5-2
for information about MDI-X ports.)
For 10BASE-T connections, use Category 3 (or higher) UTP cable. When using
10BASE-T/100BASE-TX MDAs, use only Category 5 UTP cable.
Figure 5-1. RJ-45 (8-Pin Modular) Port Connector
18
616EA