Nortel Networks 10BASE-T Switch User Manual


 
Using the BayStack 410-24T 10BASE-T Switch
4-6
309985-A Rev 00
Port Connection Problems
You can usually trace port connection problems to either a poor cable connection
or an improper connection of the port cables at either end of the link. To remedy
these types of problems, make sure that the cable connections are secure and that
the cables connect to the correct ports at both ends of the link.
Port connection problems are also traceable to the autonegotiation mode or the
port interface.
.
Note:
Operating temperature for the switch must
not exceed 40°C (104°F). Do not place the switch
in areas where it can be exposed to direct
sunlight or near warm air exhausts or heaters.
The Activity LED for a
connected port is off or
does not blink (and you
have reason to believe
that traffic is present).
The switch is experiencing a
port connection problem.
The switch’s link partner is not
autonegotiating properly.
See
Port Connection Problems” on page 4-6.
The Status LED is off. A fatal error was detected by
the self-test.
Cycle the power to the switch (disconnect and
then reconnect the AC power cord).
If the problem persists, replace the switch.
The Status LED is
blinking.
A nonfatal error occurred
during the self-test.
Cycle the power to the switch (disconnect and
then reconnect the AC power cord).
If the problem persists, contact the Nortel
Networks Technical Solutions Center.
Table 4-2. Corrective Actions
(continued)
Symptom Probable cause Corrective action