Nortel Networks 10BASE-T Switch User Manual


 
309985-A Rev 00
5-1
Chapter 5
Default Settings
Table 5-1 lists the factory default settings for the BayStack 410-24T switch
Table 5-1. Factory Default Settings for the BayStack 410-24T Switch
Appears in this CI screen Field Default setting
IP Configuration/Setup (page 3-7) BootP Request Mode BootP Disabled
In-Band Stack IP Address 0.0.0.0
(no IP address assigned)
In-Band Switch IP Address 0.0.0.0
(no IP address assigned)
In-Band Subnet Mask 0.0.0.0
(no subnet mask assigned)
Default Gateway 0.0.0.0
(no IP address assigned)
SNMP Configuration (page 3-12) Read-Only Community String public
Read-Write Community String private
Trap IP Address 0.0.0.0
(no IP address assigned)
Community String Zero-length string
Authentication Trap Enabled
Link Up/Down Trap Enabled
System Characteristics (page 3-14) Reset Count 1
Last Reset Type Power Cycle
Power Status Primary Power
sysContact Zero-length string
(continued)