Filter
Top Products
Web OS 10.0 Application Guide
Chapter 6: Server Load Balancing
127
212777-A, February 2002
The ports are configured as follows:
7. Enable, apply, and verify the configuration.
Examine the resulting information. If any settings are incorrect, make the appropriate changes.
8. Save your new configuration changes.
NOTE – You must apply any changes in order for them to take effect, and you must save
changes if you wish them to remain in effect after switch reboot.
9. Check the SLB information.
Check that all SLB parameters are working according to expectation. If necessary, make any
appropriate configuration changes and then check the information again.
>> Virtual server 1# /cfg/slb/port 1 (Select physical switch port 1)
>> SLB port 1# server ena (Enable server processing on port 1)
>> SLB port 1# ../port 2 (Select physical switch port 2)
>> SLB port 2# server ena (Enable server processing on port 2)
>> SLB port 2# ../port 3 (Select physical switch port 3)
>> SLB port 3# server ena (Enable server processing on port 3)
>> SLB port 3# ../port 5 (Select physical switch port 5)
>> SLB port 5# client ena (Enable client processing on port 5)
>> SLB port 5# ../port 6 (Select physical switch port 6)
>> SLB port 6# client ena (Enable client processing on port 6)
>> SLB port 6# .. (Select the SLB Menu)
>> Layer 4# on (Turn Server Load Balancing on)
>> Layer 4# apply (Make your changes active)
>> Layer 4# cur (View current settings)
>> Layer 4# save (Save for restore after reboot)
>> Layer 4# /info/slb/dump (View SLB information)