Filter
Top Products
C-106 MSC8101ADS RevB User’s Manual MOTOROLA
SCND_CFG_BYTE_READ,
THIRD_CFG_BYTE_READ,
FOURTH_CFG_BYTE_READ,
F_PD[4..1],
T1_EN_OUT_NODE,
T234_EN_OUT_NODE,
CODECEN_OUT_NODE,
FETHIEN_OUT_NODE,
CONF_ADD[0..1],-- CONFIGURATION ADDRESS
CFG_BYTE0[0..7],
CFG_BYTE1[0..7],
CFG_BYTE2[0..7],
CFG_BYTE3[0..7],
END_OF_FLASH_READ,-- “1” if DSP has ended Flash reading
END_OF_ATM_READ,-- “1” if DSP has ended ATM reading
DATA_HOLD_END, -- “1” if Data_Hold counter has reached its limit
EE0_HOLD_END, -- “1” if EE0_Hold counter has reached its limit
EE45_HOLD_END, -- “1” if EE45_Hold counter has reached its limit
END_OF_IMPULSE, -- End of PORESET pulse when divider will achive max value
END_OF_WD_TIMER, -- End of WD count
EEPROM_ENABLE, -- Access to EEPROM is available (write/read)
RESETS,
CLEAR_TO_WD_CTRL, -- Misc Node
WritetoBcsr,
PRST_Ensure_END -- End of Altera PRST count
: NODE;
%
****************************************
********* BCSRs Bits Description *******
****************************************
%
%********************************************************************************
* BCSR0 *
********************************************************************************%
HOSTCSP, -- BCSR0 Bit 0. Host CS Polarity
HOSTRQAC, -- BCSR0 Bit 1. Host Request or Acknowledge Select
HOSTTRI, -- BCSR0 Bit 2. Host Request or Acknowledge Enable
T1_1EN~, -- BCSR0 BIT 3. T1 port 1 enable
T1_234EN~, -- BCSR0 Bit 4. T1 ports 1,2,3 are enable
FrmRst~, -- BCSR0 Bit 5. Framer Reset
SIGNAL_LAMP_0~,-- BCSR0 Bit 6. LED0 illuminate command.
SIGNAL_LAMP_1~,-- BCSR0 Bit 7. LED1 illuminate command.
%*******************************************************************************
* BCSR1 *
********************************************************************************%
SBOOT_EN~, -- BCSR1 Bit 0. Serial BOOT Enable
CODEC_EN~, -- BCSR1 Bit 1. CODEC with Ethernet Enable
ATM_EN~, -- BCSR1 Bit 2. ATM Port enable
ATM_RST~, -- BCSR1 Bit 3. ATM Port Reset
FETHIEN~, -- BCSR1 Bit 4. Fast Ethernet Port Initial enable
FETH_RST~, -- BCSR1 Bit 5. Fast Ethernet Port Reset
RS232EN_1~, -- BCSR1 Bit 6. RS232 port 1 enable
RS232EN_2~, -- BCSR1 Bit 7. RS232 port 2 enable
%********************************************************************************
Frees
cale Semiconductor,
I
Freescale Semiconductor, Inc.
For More Information On This Product,
Go to: www.freescale.com
nc...