Filter
Top Products
161
Setting Conditions for Communications with Host by Using Memory Switches Section 6-7
• To quit the communications speed setting screen without setting the com-
munications speed, press the Abort touch switch. The NT631/NT631C
returns to the memory switch setting screen (4/4) and the previous com-
munications speed remains in effect.
On completion of communications speed setting, the NT631/NT631C returns
to the memory switch setting screen (4/4).
To set other memory switches, select the relevant screen using the [ ] (next
screen) or [ ] (previous screen) touch switch, then make the setting.
• To confirm the settings and quit the memory switch setting screen, press
the Quit touch switch. The settings made last will be set and the NT631/
NT631C will return to the MAINTENANCE MODE MENU screen.
• To quit the memory switch setting screen without confirming the settings,
press the Abort touch switch. The NT631/NT631C will return to the MAIN-
TENANCE MODE MENU screen with the previous settings still in effect.
In this example, serial port A is used.
Press the Quit touch switch.
Display the data bits to be set (7 bits or 8 bits)
by pressing the Data Bit Length touch switch.
Display the stop bits to be set (1 bit or 2 bits)
by pressing the Stop Bit Length touch switch.
Display the parity to be set (None, even, odd)
by pressing the Parity Bit touch switch.
Display the communications speed to be set
(1200, 2400, 4800, 9600, 19200, 38400 bps.)
by pressing the Comm. Speed touch switch.
Display the condition of the flow control to be
set (None, RS/CS, XON/XOFF) by pressing
Flow Control touch switch.
If the RS-422A is selected for serial port B
setting, RS/CS is not displayed.
Display presence or absence of the response
by pressing the Response touch switch.
The setting option changes each time the
touch switch is pressed.