Packard Bell ST8000 Computer Drive User Manual


 
PRINTER NOTE: Page size 9” x 9.25”. Align this page to top, right hand corner. Back box bleeds off
top and right edge. Left side of page extends to 9.25 inches.
6 Install a two-channel Ultra Extender Feature card
into the empty card slot vacated in the previous step
and tighten the thumb screws.
Ultra Extender
Option Card
I/O Interface Card
Slave Cabinet
7 Connect one end of a 3 meter data cable to the
Channel #1 connector on the RAID Controller.
2-CH Ultra
Extender Card
2-CH Ultra
Extender Card
TOP Slave #1TOP Master
Host Computer #1
Dual-Bus Module
Dual-Bus Module
Ultra Wide SCSI
Controller
SAF-TE Card
SAF-TE Card
I/O Interface
Card
I/O Interface Card
1 meter Ultra Wide SCSI Jumper
1 meter Ultra Wide SCSI Jumper
Ultra Wide SCSI Data Cable (3 meters)
Ultra Wide SCSI Data Cable (3 meters)
Chl #1
Chl #0 Chl #1
Chl #0 Chl #1
Chl #0 Chl #1
Chl #0 Chl #1
Chl #2
8 Connect the other end of the data cable to the
Channel 0 connector on the upper or right side two-
channel Ultra Extender Option card installed in the
master cabinet.