Filter
Top Products
PRINTER NOTE: Page size 9” x 9.25”. Align this page to top, right hand corner. Back box bleeds off
top and right edge. Left side of page extends to 9.25 inches.
One Dual-Bus Cabinet and Two Single-Bus Cabinets
With this configuration you will have up to twelve (12)
drives per controller channel. If you are using multiple
RAID Controllers you can further expand your capacity
by using up to four controllers per CPU system.
1 Power off your computer system or workstation.
2 Be sure to complete the “Setup” and “Component
Installation” sections described earlier in this Guide.
The DEU ships from the factory with I/O Interface
cards installed in both card slots. Therefore during
installation, you may be required to remove one or
both I/O Interface cards.
3 Identify which subsystem will be the master
cabinet. Loosen the two thumb screws and remove
the I/O Interface card installed in the lower or left
side card slot of the master cabinet.
Ultra Extender
Option Card
I/O Interface Card
4 Install a two-channel Ultra Extender Option card
into the lower or left side card slot where the I/O
Interface card was removed and tighten the thumb
screws.
5 On the subsystem that will be the slave #1 cabinet,
remove the I/O Interface card by loosening the two
thumb screws and removing the card in the upper or
right side card slot.