Filter
Top Products
PRINTER NOTE: Page size 9” x 9.25”. Align this page to top, right hand corner. Back box bleeds off
top and right edge. Left side of page extends to 9.25 inches.
Default Configurations
The following table provides the default SCSI ID
settings that will be set by subsystem processor when a
specific configuration is chosen in the OCP Menu
option SAFTE CHAIN ID setting.
Master
Cabinet -
Single-Bus
Mode
Master
Cabinet -
Dual-Bus
Mode
Slave 1
Cabinet -
Single-Bus
Mode
Slave 1
Cabinet -
Dual-Bus
Mode
Slave 2
Cabinet -
Single-Bus
Mode
Slave 2
Cabinet -
Dual-Bus
Mode
941391313
Upper
821281212
Bay
611161111
501051010
4499913
Lower
2288812
Bay
1166611
0055510
When two single-bus cabinets are installed as a Master
and a Slave system, two drive slots will be unavailable
to the controller. Under this condition you will be
required to manually configure these IDs setting. The
two upper bay disk drive slots on the Slave system
should be set with the ID setting of “XX.” These two
drive slots will then be taken off bus.