Filter
Top Products
PRINTER NOTE: Page size 9” x 9.25”. Align this page to top, right hand corner. Back box bleeds off
top and right edge. Left side of page extends to 9.25 inches.
TOP Slave #1
TOP Master
Host Computer #1
Single-Bus Module
Single-Bus Module
Ultra Wide SCSI
Controller
Available Drive
Unavailable Drive
I/O Interface Card
I/O Interface Card
1-CH Ultra
Extender Card
1-CH Ultra
Extender Card
SAF-TE Card SAF-TE Card
1 meter Ultra Wide SCSI Jumper
Ultra Wide SCSI Data Cable (3 meters)
Chl #1
Chl #0 Chl #1
Chl #0 Chl #1
Chl #0 Chl #1
Chl #0 Chl #1
6 Connect one end of a 3 meter data cable to the
Channel #1 connector on the RAID Controller.
7 Connect the other end of the data cable to the
Channel 1 connector on the upper or right side
single channel Ultra Extender Option card installed
in the master cabinet.
8 Connect one end of a 1 meter jumper cable to the
Channel 0 connector on the lower or left side I/O
Interface card in the master cabinet.
9 Connect the other end of the 1 meter jumper cable to
the Channel 1 connector on the upper or right side
single channel Ultra Extender Option card installed
in the Slave #1 cabinet.
Note: SCSI termination is automatic and requires no
user configuration.
10 Power on the DEU subsystems. After the power-on
self-test has completed, HDD Status and Channel
Mode LEDs will be solid green.
11 Access the Options menu on the Operator Control
Panel and choose the SAFTE CHAIN ID selection.
Set the cabinet identities of the master and slave
subsystems. Refer to “SAFTE CHAIN ID” described
earlier in this Guide.